Removing Punch Waste
If the punch receptacle is full, remove punch waste by following the procedures stated in the animation
that appears on the screen.
• While " Hole Punch Receptacle is full." is displayed, you cannot use the Punch function.
• " Hole Punch Receptacle is full." is displayed until the punch waste box is reinstalled.
• If the message is still displayed, reinstall the punch waste box.
• The message " Hole Punch Receptacle is full." may appear even when the punch waste box is not
yet full. If this happens, the position of the punch waste box (indicated by the arrow as shown) may
be blocked by punch waste. Remove the punch waste.
• 3000-sheet finisher:
To Next Page
Loading...
Need help?
Power
Performance
Print Specifications
Weight and Dimensions
