Ricoh Aficio SP C830DN User Manual

Message Cause Solution
"85: Error" The specified graphics
library is unavailable.
• Check that the data is valid.
• Decrease the number of files sent
to the printer or install the optional
SDRAM module. For details about
installing SDRAM module, see
"Installing the SDRAM module",
Operating Instructions.
"86: Error" Parameters of the control
code are invalid.
Check the print settings.
"91: Error" Printing was canceled by the
auto job cancel function due
to a command error.
Check that the data is valid.
"92: Error" Printing was canceled
because [Job Reset] or the
[Suspended] key was
selected on the printer's
control panel.
Perform the print operation again as
necessary.
"98: Error" The printer could not access
the hard disk correctly.
Turn the main power switch off and then
back on again. If the message appears
frequently, contact your service
representative.
"Address Book is currently in
use by another function.
Authentication has failed."
The printer currently cannot
perform authentication
because the Address Book
is being used by another
function.
Wait a while, and then retry the
operation.
"Auto-registration of user
information has failed."
Automatic registration of
information for LDAP
Authentication or Windows
Authentication failed
because the Address Book
is full.
For details about automatic registration
of user information, see Security Guide.
"Classification Code is
incorrect."
The classification code has
not been entered, or the
classification code has been
entered incorrectly.
Enter the correct classification code.
3. Troubleshooting
96

Ricoh Aficio SP C830DN Specifications