Ricoh J006 - Printer Status Monitor Errors

SM 8-9 J001/J003
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
SERVICE TECHNICIAN (ST) and/or
NATIONAL RECLAMATION CENTER
(NRC) ACTION
(3) ST Descriptions
3-1 Operation impaired by other causes. 1. Harness disconnected, damaged.
2. Sensor damage (bypass set sensor).
3. Control board malfunction.
4. DC relay board abnormal.
5. Drive gears damaged.
6. Encoder sheet dirty.
7. Carriage shaft, bushings not clean.
8. Carriage pressure roller of the timing belt is not
clean.
9. Carriage encoder sensor is damaged.
1. Check harness, replace (NRC).
2. Replace bypass set sensor (ST),
replace the registration sensor
(NRC).
3. Replace control board (NRC).
4. Replace DC relay board (NRC).
5. Replace drive gears (NRC).
6. Clean the encoder sheet (ST).
7. Clean the carriage shaft, bushings
(ST).
8. Clean or replace the pressure roller
of the carriage drive belt (ST).
9. Replace the carriage encoder sensor
(NRC).
8.1.7 PAPER MISFEED - JAM: TRAY 2 (J003)
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
SERVICE TECHNICIAN (ST) and/or
NATIONAL RECLAMATION CENTER
(NRC) ACTION
Transport jam occurred. (Tray 2)
When the paper was feed from Tray 2, the
registration sensor detected the leading edge, but
the trailing edge sensor did not detect the trailing
edge because the stopped in the paper path.
Ask the operator to try the following procedures
to remove and prevent paper transport jams when
feeding from Tray 2. Also, check inside the printer
and Tray 2 for paper. If you find paper inside the
printer or tray, remove it, and then press the
[Paper Feed] key.
1. Paper unexpectedly started double-feeding
more than 1/1000.
2. Paper that does not meet specifications was
used.
3. Damage.
1. Do not continue to use unapproved paper.
2. Use only paper that meets specifications.
3. Repair (ST) or replace (NRC).
(1) Check for paper inside the printer. Paper
inside the printer can cause double feeding.
Switching to a different type of paper and
changes in the environment can also cause
double-feeding. Do not use continuous form
feed paper; if you use such paper separate
each sheet before loading. The printer is
guaranteed for fewer than 1 jam per 1,000
sheets when using approved paper.
Unexpected double-
feeding (due to static electricity,
friction between front/back of sheets), occurs
frequently when adding sheets.
Do not continue to use unapproved paper.
(2) Check the type and condition of the paper,
then do the following procedures.
Use only paper that meets specifications
(including restrictions).
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA