30
English
Basic Operations
Powering On the Projector
1. Ensure that the power cord and signal cable are securely
connected. The Power indicator will turn red.
2. Remove the lens cap.
3. Turn on the lamp by pressing the button on the control
panel or the button on the remote control. The Power
indicator will ash blue.
The startup screen will display and the Power indicator will
turn blue.
4. The rst time you use the projector, you will be asked
to select the preferred language. Turn on your source
(computer, notebook, video player, etc.) The projector will
detect your source automatically.
Make sure that the “Auto Source” has been set to “On”.
Powering On/Off the Projector
Turn on the
projector rst and then
the signal sources.
N
o
t
e
Lens Cap
Enter
AV Mute
Keystone Volume
Auto
Menu
Input
ECO
Computer
1
Video
2
HDMI
3
Digital A
4
Digital B
5
Magnify
+6
Aspect
7
Freeze
8 -9
Picture
Status
0 MHL
Power
1
2
OR
CAUTION:
• Do not look into the lens while the lamp is on. The strong light from the
lamp may cause damage to your eyesight.
• Do not block the air intake or exhaust. Doing so could cause a re due to
internal overheating.
• Do not place your hands, face, or other objects near the air exhaust, the
lamp cover or the bottom of the unit. Doing so could result in injury and/or
damage the object.
If you connect
multiple sources at
the same time, press
“Input” on the control
panel or the desired
source button on the
remote control to
switch inputs.
N
o
t
e
To Next Page
Loading...
Need help?
General
