64
English
LAN Control
Alert Settings
You can send email alerts when an error occurs.
You can carry out settings for alert mail in this section.
►
Alert types
Check the type of error for which you want to send alert mail.
►
Alert mail notification
Check and perform the following settings.
►
SMTP Setting
Set the following:
• SMTP Server: Server address (server name) (SMTP server)
• From: e-mail address of the sender
• User Name: User name of the mail server
• Password: Mail server password
►
Email Setting
• Mail Subject
• Mail Content
• To: Enter the e-mail address of the sender.
• Click "Apply” to fix the value.
Only alphanumeric
characters and
symbols can be used
in the password. The
maximum number of
characters is 32.
If the characters
entered in the Current
Password eld and the
characters entered in
the Conrm Password
eld do not match,
error message will be
displayed. In this case,
re-enter the password.
N
o
t
e
When you have
changed the settings,
verify that the
e-mail settings are
done correctly. It is
recommended that you
send a test mail.
E-mail transmission
protocol supports only
SMTP. Other protocols
cannot be used.
When Japanese or
Chinese characters
are used in an e-mail
content, the e-mail
may be received with
unreadable characters.
In such case, please use
English characters for
the e-mail content.
N
o
t
e
Conditions Conditions for sending Title of e-mail
[Fan Error] Cooling fan has stopped Fan Lock:xxx.xxx.xxx.xxx*
[Lamp Error] Lamp does not turn ON Lamp Fail:xxx.xxx.xxx.xxx*
[High Temp
Warning]
Temperature of the unit
is high
Over Temperature:xxx.xxx.xxx.
xxx*
To Next Page
Loading...
Need help?
General
