76
English
Troubleshooting
Problem: Image is reversed
Select “SCREEN > Projection Mode” from the OSD menu to
adjust the image.
Problem: Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will
not turn on until the lamp module has been replaced. To replace
the lamp, follow the procedures in the “Replacing the Lamp”.
Problem: Indicator lighting message
Status
POWER
indicator
LAMP
indicator
TEMP
indicator
(Blue) (Red) (Red) (Red)
Normal Operation
Standby
Normal (Power ON)
Powering up
Flashing
(0.5 sec)
Cooling
Flashing
(0.5 sec)
Programming
Warning
Lamp failed
Over Temperature
Fan Lock
Flashing
(0.5 sec)
Steady light =>
No light =>
N
o
t
e
To Next Page
Loading...
Need help?
General
