Test Inspection Procedure
Check points
Check item Check point
Firmware version All firmware version must be the latest version
TB implementation Related TB must be implemented
Exterior The exterior must be undamaged.
Logo
Missing logo, missing prints and blurred prints are
unacceptable
Lamp cover It should be locked in the correct place.
Zoom in/out The function should work smoothly
Keypad All keypad keys must operate smoothly
OSD Reset
After the final QC step, we have to erase all saved change again and restore the OSD default setting.
The following actions will allow you to erase all end-users' settings and restore the default setting:
1. Press the “Menu” key to enter the OSD menu.
2. Select "Setting" and then execute the "Reset" function.
5. Test & Inspection
66
To Next Page
Loading...
Need help?
General
