Ricoh Ri 3000 - Platform Did Not Lower;Engage

151
8: Platform Did Not Lower/Engage
Figure 11.8-1: Platform Error
If the maintenance station platform does not lower or rise during its normal operation, the control panel
will display three options: Retry, Cancel, and Ignore
 Ignore function tells the printer to ignore the sensor and proceed with the next action
 Cancel function cancels any operations the operator intended to perform
 Retry function moves the platform in an attempt to get the see if the sensor is recognized
Figure 11.8-2: Check Platform Limit State
If the Maintenance station is not being detected, you can verify if the sensor is operating correctly in the
<Diagnostics> Menu under the Exercise Motion tab.