46
Chapter 3: Printer Controls
1: Power Switches
The power is controlled by two switches: The main power switch and control panel <POWER> button.
The main power switch is on the rear left side. Switch the power on.
2: Control Panel
The Ri 3000 and Ri 6000 Control Panel consists of a touch LCD display, a circular power/print button and a
USB port on the right side. The control panel layout is shown below in (Figure 3.2-1).
Figure 3.2-1: Control Panel
When the main power switch is turned on, it powers the printer’s power supply control board. Now
press the <POWER/PRINT> button to the right of the control panel, this fully powers up the printer.
The control panel will display a splash screen and then the main menu.
To power down, simply press the Control Panel power key and then turn off the main power switch on
the rear of the unit. If the carriage is not in home position over the maintenance station and the
capping plate is not sealing against the nozzle plates, turn the unit back on to initialize the unit and
then power down again. It is recommended that the printer is fully powered on (Back and front) at all
To Next Page
Loading...
