43
Figure 2.7-4: Print Head Clean Menu
If your nozzle check only shows that the white ink channels are not firing fully then select Clean White
Channels, indicated by the orange arrow. If you need to clean any of the CMYK channels, select the CMYK
channel clean indicated by the green arrow. If you need to clean both CYMK and White channels, select
the 6 channel clean indicated by the blue arrow.
When the clean is completed select Close and pop up will disappear.
You now need to perform another Nozzle Check to check the status of your print nozzles. If the check is
still not good, repeat the Print Head Cleans until it is. If the Nozzle Check Pattern looks good, then you
are finished with the initial printer setup.
8: Printer Software Program Requirements
Once the ink cartridges are installed and ink flow has been established, it’s time to install the
AnaRIP software onto the PC. Your PC must have Microsoft Windows Vista, Windows 7, Windows 8, or
Windows 10 operating system, or on a MAC, some kind of Windows emulation must be running such as
Parallels or Boot Camp. The computer also needs to have an USB 2.0 port.
AnaRIP Printer Software Program Download and Installation
Prior to setting up your printer, you will need to download the latest version of AnaRIP software for your
printer. You can find this software at www.AnaJet.com/downloads . Locate the latest version of AnaRIP
for your specific printer. You will then be routed to a page with download and installation instructions.
When the software is installed double click the AnaRIP icon to launch the software and then connect the
printer to the computer using the provided USB cable.
Do not use a USB cable longer than 10 feet or use an unpowered USB Hub since data transmission loss can
occur. After the cable is installed place an image into the software by going to File and then Place an
image.
To Next Page
Loading...
