22
Other Information for This Machine
Laws and Regulations
Legal Prohibition
Do not copy or print any item for which reproduction is prohibited by law.
Copying or printing the following items is generally prohibited by local law: bank notes, revenue
stamps, bonds, stock certificates, bank drafts, checks, passports, driver's licenses. The preceding list is
meant as a guide only and is not inclusive. We assume no responsibility for its completeness or
accuracy. If you have any questions concerning the legality of copying or printing certain items,
consult with your legal advisor.
FCC Statement (USA):
• Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
• Caution: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
• Caution: Properly shielded and grounded cables and connectors must be used for connections to
host computer (and/or peripheral) in order to meet FCC emission limits.
User Information on Electrical and Electronic Equipment:
Caution: An AC adapter with ferrite core must be used for RF interference suppression.
Note to Users in California (USA):
• Perchlorate Material - special handling may apply. See:
www.dtsc.ca.gov/hazardouswaste/perchlorate
Laser Emitter Warning and Laser Aperture Warning
• The Obstruction Sensor detects any obstruction on the Print Table, such as wrinkles on the shirts,
which can damage the print heads. On the left-hand side of the printer, there is an Obstruction Laser
Diode, which generates the laser. On the right-hand side, there is the Obstruction Laser Sensor.
Laser (North America):
• This equipment complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser
Notice No. 50, dated June 24, 2007 for class II laser product. This equipment contains one AlGaInP
laser diode, 660 nanometer wavelength. The beam divergence angle is 21 degrees (minimum) and 29
degrees (maximum) in the vertical direction, and 7 degrees (minimum) and 11 degrees (maximum) in
the horizontal direction, and laser beams are generated in ContinuousWave (CW) mode. The
maximum output power of the light source is 1 milliwatt.
To Next Page
Loading...
