50
4: Moving Print Table
• When moving the Print Table, be careful so that your hands or fingers are caught with it. Otherwise,
injury may result.
Pressing the <TABLE> button on the Control Panel will move the Print Table in one
direction. Pressing the <TABLE> button while the Print Table is moving stops it. A
third pressing will move the Print Table in the opposite direction. The forward most
position is called the Load Position where garments are loaded. The far rear position
is called the Home Position or Print Start Position. If the printer is shut down, the
Print Table will rest in the Home Position.
Figure 4.4-1: Print Table Positions at Each End
5: Adjustment of Print Table
• When moving the Print Table, be careful so that your hands or fingers are caught with it. Otherwise,
injury may result.
The Print Table height is adjustable up to 2.3 inches and 2.7 inches manually using the adjustment knob
located underneath the table. The proper height should be set depending on the thickness of the
garment or substrate being printed on.
Proper Print Table height adjustment is very important. If the garment’s surface is too far from the Print
Head Nozzle Plate, the print quality will be fuzzy and ink over-spray may be visible. If it is too close to the
Nozzle Plate, an obstruction error may occur or worse the garment could scratch and damage the Print
Head Nozzle Plate coating. The optimal distance between the lowest point of the Print Head Nozzle Plate
and the top surface of a loaded garment is in the range of .06-.12 inches (1.5-3 mm)
To Next Page
Loading...
