48
3: Buttons
The <POWER> button powers on the print engine. Make sure you
have switched the Master Power Switch on the back of the printer
first. Power button should glow with a blue light.
The <TABLE> button moves the Print Table back and forth. Pressing
it while the Print Table is moving will stop the table. Pressing it again
will move the table in the opposite direction. When the Print Table
reaches the front or rear limit, the table will stop automatically.
The <PRINT> button initiates the printing operation of the job shown in the
Current Job page display. The current print job usually is the last job
sent from the computer, or selected from Jobs List, or loaded from USB
drive. When the blue LED Print Ready lights up behind the <PRINT>
button, the printer is ready to print. Press the <PRINT> button. The
table will start moving into the printer to initiate printing operations.
The <PRINTCHECK> button invokes Nozzle Check Pattern operation
and clean functions. The <PRINT> button must be pressed to start
printing the Nozzle Check.
The AUTO Table Height Adjustment button allows you to adjust the
height of the print table to accommodate different thicknesses of
garments and substrates when the Print Menu is displayed. There is
also a manual adjustment knob under the print table.
The<CANCEL> button is used to cancel an operation, usually the Print
operation or Print Table movement.
The <CLOSE> button will close the Menu pop-up
The <MENU> button brings up the MAIN MENU page
The <MAINTENANCE> button found in the main menu screen
opens up a maintenance functions popup to access the motion
controls, print counters, ink fills and firmware updates.
The <SETTINGS> button found in the main menu screen opens up
the printer settings popup to access the printer and system
settings, jobs handling, pre-print checks and network settings.
The <DIAGNOSTICS> button found in the main menu screen opens
up the printer settings popup to access to the exercise motion
functions, print head settings and printer information.
The <ABOUT PRINTER> button found in the main menu screen
opens up the printer settings popup to access the printer
information.
The <POWER OFF> button found in the main menu screen will
power the printer down. The printer can also be powered down
by holding down the power/print button.
The <ADVANCED> button found on the main menu is activated by
pressing the print button 8 times with the main menu open. This
brings up the technical menu and is used to perform maintenance
checks on the printer.
To Next Page
Loading...
