37
Figure 2.4-4: Splash Screen Figure 2.4-5: Printer LCD Display
5: Before Filling the Printer with Ink
Before we add ink to the printer we will to do a quick check to ensure that the printer is operating
correctly. To do this we will power up the printer at the control panel and observer that following printer
functions are done. After pressing the <POWER> key on the control panel, the control panel display will
show the Ri 3000/Ri 6000 flash screen and then it will initialize and finish at the Jobs Screen. During this
initialization observe the printer movement through the table opening. You should see the print carriage
move to the right and then back to its home position and then the print table will move out to its load
position.
STOP – If this is a new printer, contact your RICOH Ri 3000/Ri 6000 supplier before going any
further to schedule your setup and training session with your certified technician to complete the
installation process.
Download the User Manual and AnaRIP software at AnaJet.com/downloads
6: Filling the Printer with Ink
•Keep infants away from polythene materials (bags, etc.) used to wrap options and cartridges/bottles for
ink, cleaning solution, HV storage solution, and pretreatment liquid. Suffocation may result if polythene
materials are brought into contact with the mouth or nose.
• When swallowing or inhaling ink, cleaning solution, HV storage solution or pretreatment liquid, or when
getting them in the eye, follow the guidance in the appropriate safety data sheet (SDS). Download the SDS
from the AnaJet website at http://anajet.com/technical-documentation
• Place ink, cleaning solution, HV storage solution, and pretreatment liquid in a cool, well-ventilated place
out of the reach of children.
• Keep waste ink, containers for ink, cleaning solution, HV storage solution, and pretreatment liquid, and
To Next Page
Loading...
