36
at least once a year. Allowing dust to build up on the plug constitutes a fire hazard.
• When performing maintenance on the machine, always turn off the power switch on rear of the machine.
Power source
• 100-240V, 2A, 50/60Hz
Voltage must not fluctuate more than 10%.
Please be sure to connect the power cable to a power source as above.
Confirm that the wall outlet is near the machine and freely accessible, so that in event of an
emergency, it can be unplugged easily.
Plug in the provided power cord to a surge protector connected to a wall outlet. Ri 3000/Ri 6000
printer power supplies will accommodate voltages ranging from 100 to 2450 volts. Next, plug the power cord
into the power entry module in the rear of the printer. Do not plug the USB Cable into the printer or PC at
this time.
The USB ports located on the back and front panels of the printer are to be used with USB flash drives
ONLY!
The USB B port is for connecting the printer to a PC
Figure 2.4-3: Plus in the Power Cord and USB Cables
Turn on the power switch on the rear of the Power Entry Module; this will bring power into the printer’s
power supply. Now press the large round <POWER> key on the front control panel. The printer control
panel LCD display will light up and the printer is now fully powered on and able to do its automatic ink
circulation and maintenance. (Please note due to this two-stage power on sequence that if the printer
loses power due to an outage it will not fully power on when the electricity is restored.
If you are in an area where your electrical power is inconsistent you may want to invest in an
Uninterruptible Power Supply (UPS) that will supply battery backup power to your printer during
an electrical outage.
To Next Page
Loading...
