34
Leveling the Printer
• When adjusting the machine feet to level the machine, be careful so that your hand is not caught between
the machine foot and stand. If it is caught, injury may result.
Leveling the Printer
Before the printer is turned on, the printer should be leveled. There are 6 adjustable feet under the
bottom casing of the printer that are used level the printer. Turning the feet clockwise lowers the
feet towards the ground and turning the feet counter clockwise raises the feet into the printer.
To level the printer on the left to right axis, open the printer’s top cover and place a 9” or 12”
“torpedo level” (provided) on the top rail (see figure 2.4-2). Adjust the left most or right most feet
to initially level the printer left to right. Then lower the middle feet to provide stability.
To level the printer on the front to rear axis, open the printer’s top cover and place the level on the
rail below and behind the print table (see Figure 2.4-2). Adjust the front or rear feet as needed to
level the printer on the rear axis.
Figure 2.4-2: Leveling the Printer
To Next Page
Loading...
