Paper Precautions
• Do not attempt to print on stapled sheets, aluminum foil, carbon paper, or any kind of
conductive paper. Doing so risks fire.
• If Tray 2, 3, 4 and 5 are installed, do not pull out more than one tray at a time when you are
changing or replenishing paper or resolving paper jams. Pressing down forcefully on the
machine's upper surfaces can result in malfunctions and/or user injury.
Precautions
• Print quality is not guaranteed if paper other than the ones recommended is used. For more
information about recommended paper, contact your sales or service representative.
• If paper jams occur or multiple sheets are fed at once, fan the paper before loading it.
• If you load paper when only a few sheets of paper remain in the tray, multiple sheet feeding
may occur. Remove any remaining paper, stack them upon the new sheets of paper, and then
fan the entire stack before loading it into the tray.
• Straighten curled or warped paper before loading.
• For details about available paper sizes and types for each paper tray, see page 48 "Paper
Size Specifications" and page 51 "Paper Type Specifications".
• Depending on the environment where the printer is being used, you might at times hear a
rustling noise from paper moving through the printer. This noise does not indicate a
malfunction.
• If paper cannot be fed properly because of burrs on the edges of paper, load paper upside
down.
• It is recommended to load envelopes and labels into the bypass tray.
Unusable Paper
To prevent errors and misfeeds, do not use:
Paper Precautions
53
To Next Page
Loading...
Need help?
General
