When Messages Are Displayed
This section describes the main messages that appear on the display panel and printed error logs and
reports. If other messages appear, follow their instructions.
Status Messages
Message Status
"Energy Saver Mode" The printer is in Energy Saver mode. Press any key to recover to the
normal mode.
"Hex Dump Mode" In Hex Dump mode, the printer receives data in a hexadecimal format.
Turn off the printer after printing, and then turn it on again.
"Job Suspended" All jobs are suspended. Turn off the printer, and turn it on again to
resume the jobs.
"Offline" The printer is offline and cannot print.
"Please wait..." This message may appear for a few seconds. It means the printer is
initializing, replenishing toner, or performing maintenance operations.
Wait a while.
"Printing..." The printer is printing. Wait a while.
"Printing Suspended" Printing is suspended. To resume printing, press the [Suspend/Resume]
key.
"Ready" This is the default ready message. The printer is ready for use. No
action is required.
"Resetting Job" The printer is resetting the print job. Wait a while.
"Setting change..." The printer is applying the changes made to its settings. Wait a while.
"The cooling fan is active." The fan will emit noise, but this is normal and the machine will be
operable while the fan is running. The amount of paper that can be
printed and the total operation time until the fan starts running depends
on the temperature of the location at which the machine is installed.
"Updating Certificate..." The printer is updating the @Remote certificate. Turn the power off, and
then turn it on again.
"Waiting for print data..." The printer is waiting for the next data to print. Wait a while.
3. Troubleshooting
76
To Next Page
Loading...
Need help?
General
