Ricoh SP 5300DN User Manual

If printing does not start, contact your service representative.
When the Data In Indicator Does Not Light Up or Flash
When the Data In indicator does not light up or flash after a print job starts, data is not being sent to the
printer.
When the printer is connected to the computer using the interface cable
Check that the print port setting is correct. When connecting the printer to the computer using a
parallel interface, connect using LPT1 or LPT2.
1. Open the printer properties dialog box, and then click the [Ports] tab.
For details about displaying the printer properties dialog box, see "Displaying the Printer
Driver Properties with Windows", Operating Instructions.
2. In the [Print to the following port(s)] list, check that the correct port is selected.
Network connection
For details about the network connection, contact your administrator.
3. Troubleshooting
90

Ricoh SP 5300DN Specifications

General

Print Technology	Laser
Print Resolution	1200 x 1200 dpi
Maximum Memory	2 GB
Connectivity	USB 2.0, Ethernet
Processor Speed	1.46 GHz
Maximum Paper Size	A4
Maximum Paper Capacity	2, 600 sheets
Duplex Printing	Yes
Media Sizes Supported	A4, A5, A6, B5, Legal, Letter
PDL	PCL5e, PCL6, PostScript 3
Operating System Compatibility	Windows, Mac, Linux