Message Cause Solution
"Rplcmnt Rqrd Soon:Drum
Unit"
You will need to replace the drum
unit soon.
Contact your sales or service
representative to obtain a new
unit.
"SD Card
authenticatn.failed Error
recurs, call service."
Authentication from the SD card
failed.
Turn the printer off, and then turn it
on again. If the problem persists,
contact your sales or service
representative.
"Set the Drum Unit
correctly."
The drum unit may not be installed
correctly.
Contact your sales or service
representative.
"Set the Maintenance Kit
correctly."
The fusing unit may have not been
installed correctly.
Contact your sales or service
representative.
"Set the Toner Cartridge
correctly."
The print cartridge may have not
been installed correctly.
Turn the printer off, and install the
print cartridge again.
"Standard Tray is full.
Remove the paper."
The standard tray is full. Remove the paper.
"Supply order has failed." The automatic supply order failed. The message indicates the printer
tried to order the supplies.
"This NetBIOS name is
already in use.(108/208)"
The NetBIOS name specified for
the printer is already used by
another device on the network.
Contact your network
administrator.
"The same IPv4 Address
already exists.(102/202)"
The IPv4 address specified for the
printer is already used by another
device on the network.
Contact your network
administrator.
"The selected job has
already been printed or
deleted."
This message might appear if you
print or delete a job from Web
Image Monitor.
Press Exit on the message screen.
"USB has a problem. Please
call service."
The printer has detected a USB
board failure.
Turn the printer off, and then turn it
on again. If the problem persists,
contact your sales or service
representative.
"Values set for IPv6/
Gateway addresses are
invalid.(110/210)"
The IPv6 address or gateway
address is invalid.
Check the network settings.
When Messages Are Displayed
81
To Next Page
Loading...
Need help?
General
