DG1000 Command System RIGOL
Programming Guide for DG1000
PM
In PM, the phase of carrier varies with the instantaneous voltage of the modulating
waveform. For DG1000, CH1 can output PM modulated waveform. PM commands
could be used for these settings: modulation source, modulating waveform,
modulating frequency, phase deviation and PM modulation state.
DG1000 supports following PM commands:
1. PM:SOURce
2. PM:SOURce?
3. PM:INTernal:FUNCtion
4. PM:INTernal:FUNCtion?
5. PM:INTernal:FREQuency
6. PM:INTernal:FREQuency?
7. PM:DEViation
8. PM:DEViation?
9. PM:STATe
10. PM:STATe?
To Next Page
Loading...
