To Set the Output
As shown in Figure 1-15, there are two Output buttons on the right side of the front
panel, which are used to set the Output Control. The instruction below will help you to
be familiar with these functions.
Figure 1-15 Channel Output/Counter Input
Figure 1-16 Channel Output Control
1. Channel Output Control
Press the Output button to enable/disable the signal output of CH1 or CH2.
2. Counter Input
In the Counter mode, the output connector of CH2 is used as the signal input
terminal. At the same time, the output of CH2 will be disabled automatically.
To Next Page
Loading...
