Rigol DG1022

RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG1022
2-72
Power Amplifier Settings
PA1011 power amplifier (“PA” for short hereinafter) can be connected to and
controlled by the generator for signal amplification. Before using PA, power on the
instrument and then connect USB Host of the generator with USB Device of PA via an
USB cable.
Press Utility   PA, enter the following menu.
Figure 2-80
PA Setting Interface
Table 2-31 PA Setting Menu
NOTE: For more detail about the power amplifier, please refer to the User’s Guide of
PA1011.
Menu
Settings
Explanation
Switch
Enable or Disable PA
Normal
Invert
Invert the output of PA or not
X1
X10
Set the gain of PA
OffsON
OffsOff
Turn on the switch to input the offset value:
-12V~12V
Store
Store current work state of PA to its memory