To Use Store/Utility/Help Function
As shown in Figure 1-22, there are three buttons on the operation panel, which are
used to call the store/recall, utility and help function. The instruction below will help
you to be familiar with these Functions.
Figure 1-22
Store/Recall, Utility and Help Button
1. The Store/Recall Button is used to store waveform data and configure
information.
2. The Utility Button is used to set the auxiliary system function, change the output
configure parameters, interface setting, system setting information or perform the
instrument self-test and the calibration, etc.
3. The Help Button is used to read the help information.
To Next Page
Loading...
