Rigol DG1022

RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG1022
2-10
To Set Ramp Waveform
Press the Ramp button, in the Normal Mode, the operation menu will appear at the
bottom of the screen. Set the Ramp parameters by using the operation menu.
The parameters for Ramp waveforms are: Frequency/ Period, Amplitude/ High Level,
Offset/ Low Level, Symmetry and Phase . See Figure 2-10. In the operation menu,
select Symm, and the corresponding parameter will be displayed in inverse color for
which users can make a change.
Figure 2-10
Ramp Signal Parameter Setting Interface
Table 2-3 Ramp Signal Operation Menu
Menu
Settings
Explanation
Frequency/
Period
Setting the signal’s frequency or period; the
current parameter will switch at a second press.
Amplitude/
High Level
Setting the signal’s Amplitude or High Level; the
current parameter will switch at a second press.
Offset/Low
Level
Setting the signal’s Offset or Low Level; the
current parameter will switch at a second press
Symmetry
Setting the Symmetry for Ramp Waveform
Phase
Setting the initial phase of the signal
Term Explanation:
Symmetry: The percentage that the Rising Period takes up in the whole Period.
Input Range: 0~100%