Rigol DG1022

RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG1022
2-49
Press the Utility button, enter the following interface (two pages):
Figure 2-54
Utility Settings Interface
Table 2-22 Utility System Setting
Menu
Settings
Explanation
Sync On
Sync Off
On
Off
Enable/disable the Sync Signal of CH1 through the
[Sync Out] connector on the rear panel.
CH1
Basic Setting of CH1: Impedance, Normal/Inverse
display
CH2
Basic Setting of CH2: Impedance, Normal/Inverse
display
Coupling
Settings of Channel Coupling and Channel Copy
Count
Frequency Measurement in single channel. Range:
100mHz~200MHz
Go to the next page of menus
System
Set the System Configuration
I/O
View the USB Information
Test/Cal
Do self-test and calibration operation or view the
instrument information.
PA
Setup power amplifier
Back to the previous page of menus
Save all the settings and exit
Instructions
Sync Switch Setting:
When the amplitude is low relatively, you can reduce the distortion when output
the signal by prohibiting the Sync Signal. And the current storage is in the
Non-Volatile Memory.