Rigol DS1202/4B - Manual Mode

RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DS1000B series
2-100
Manual Mode
Figure 2-130 Table 2-87 The Cursors menu
Menu
Settings
Comments
Mode
Manual
Adjust the cursor to measure X/Y
parameters manually.
Type
X
Y
Shown as vertical line to measure the
horizontal parameters.
Shown as horizontal line to measure
the vertical parameters.
Source
CH1
CH2
CH3
CH4
MATH
Select the measurement signal source.
In this mode, the oscilloscope measures the Y or X coordinate values of the cursors,
and the increments between the two cursors.
To do manual Cursor Measurements, please do as the following steps:
1. Select the Manual mode for cursor measurement by pressing soft button as:
CursorėModeėManual.
2. Select channel Source for measurements by pressing soft button as:
CursorėSourceėCH1, CH2, CH3, CH4, MATH.
NOTE: While measuring the channel with MATH, the results are valued with “d”
(division) as units.
3. Select the cursors type by pressing soft button as CursorėTypeė X or Y.
4. Move the cursors to adjust the increment between the cursors:(Details in the
following Table)