RIGOL Remote Control
4-2 User’s Guide for DSA1000 Series
4.1 Remote Control Via USB
1. Connect the devices
Connect the analyzer with you PC following with the “Figure 1-12 ”.
2. Install the USB drive
As the analyzer is a USBTMC device, the “USB Test and Measurement Device”
driver should be installed on your PC after you connect the analyzer to the PC and
turn both on.
3. Search device resource
Start-up Ultra Sigma, and the software then starts searching the analyzer
resources that have been connected with PC via USB automatically, or click
to search manually.
4. View the resource
The resources that have been searched successfully are shown in the “RIGOL
Online Resource” catalog as well as the instrument model and USB information.
See figure below.
Figure 4-1 View the resource
To Next Page
Loading...
Need help?
General
