RIGOL Troubleshooting
5-4 User’s Guide for DSA1000 Series
device condition.
Message number: -299 to -200.
(3) Device Specific Error: indicates a device specific error is generated when the
commands cannot be correctly executed due to current settings of the
hardware and software of the device.
Message number: -399 to -300 (defined in SCPI standard) and 300 to 1000.
(4) Query Error: indicates a query error is generated when the output queue
controller (see IEEE488.2,6.5.7) fails to follow the Message Exchange
Control Protocol under any of the conditions below: ( see IEEE488.2,6.1.10)
When trying to read the output queue, the queue has no data or is being
suspended.
Data in the output queue has been lost.
Message number: -499 to -400.
3. Status Message: to warn you that the analyzer is now in a certain condition and
should be paid attention to. The messages are always marked with an
icon
and displayed on the screen until the Esc key has been pressed or the *CLS
command is used. The messages are stored in corresponding status register, and
can be queried by sending :Status: or :SYSTEM:ERROR[:NEXT]?.
Message number: 200 to 299.
To Next Page
Loading...
