139
Messages
Data number 100 reached during manual store (memory card)
Data count has Datennummer Contador de datos
reached 100. 100 erreicht. ha llegado a no 100
Change Data Number. Datennummer ändern. Cambiar no de dato.
Push any key. Taste drücken. Presione un botón.
100 addresses were reached during manual store on memory card, or
address number is 100.
<User action>
Change address to lower number and overwrite.
Timer mode end
Timer mode Measure- Timer-Modus- Medición en modo
ment is completed. Messung beendet. temporizador está
completada.
Push any key. Taste drücken. Presione un botón.
Measurement in timer mode has ended.
Invalid operation
Invalid operation! Bedienungsfehler! Operación
no válida
For example, this message appears when main display shows frequency
C-weighting and sub display (auxiliary processing value) is set to L
AI
etc.
<User action>
Make appropriate settings for measurement conditions. (To measure L
AI
set main display also to A weighting.)
To Next Page
Loading...
