Risco Agility 3 - Partition Unsetting; Duress Unsetting; Unsetting after an Alarm

Agility 3 User Manual
Page 15
Enter your user code and click UNSET
Partition unsetting:
Partition unsetting enables you to unset individual partitions within a set system
To unset using
Procedure for Partition Unsetting
Quick mode: / / >
High security mode: / / > > Code
/ / > > code or proximity tag.
Press the  button. All partitions assigned to the button will be
unset.
Send SMS: [Code][U] [Partition 1,2 or 3]. Example 1234U1. For more
information refer to page 22.
Duress unsetting:
If you are ever coerced into unsetting your system, you can comply with the intruder's
wishes while sending a silent duress alarm to the Alarm Receiving Centre. To do so,
you must use a special duress code, which when used, will unset the system in the
regular manner, while simultaneously transmitting the duress alarm. Confer with your
engineer which of the user's codes is defined as a duress code.
Note: Under no circumstances must the duress code be used haphazardly or without
reason. Alarm Receiving Centres, along with Police Departments, treat duress
codes very seriously and take immediate action.
Unsetting after an alarm:
When silencing an alarm the system goes into a unset state. After the system is unset the
sounders will sound 4 sounder chirps indicated that an alarm occurred in the system. On
the keypad, press for 2 seconds in order to view information about the last alarm.