Risco Agility 3 - Receiving Calls from the System

Agility 3 User Manual
Page 20
Operation
Quick Key Combination
Changing Zone Omit status
Press [3] followed by the zone number and then [#][9]
Operating Programmable
outputs
Press [4] followed by the output number
Changing Follow Me(FM)
numbers
Press [5] followed by the FM number and [#][2].
Enter the new phone number and press [#][1].
Listen in to the premises
Press [6][1]
Talking to the premises
Press [6][2]
Listen and Talk to the premises
Press [6][3]
Recording messages that are not
included in the message bank (5
messages)
Press [7][1]… [5]
Recording an opening message
Press [7][6]
Exiting the System
Press [0]
To return to the previous menu
Press [*]
To repeat the menu options
Press [#]
Receiving Calls from the System
Upon event occurrence, such as alarm activation, the system informs you of security
situations, for example, intrusion or fire, by calling you and announcing a pre-recorded
event announcement message, followed by the Acknowledge menu. The system can call
up to 16 Follow Me numbers, enabling you, a relative or neighbour to be informed of the
security situation. You can then take the appropriate action, whether this is to inform the
authorities or acknowledge the event and remotely operate the system.
Notes: Follow Me messages are performed only after reporting to the Alarm Receiving
Centre.
Follow Me numbers are assigned certain events for which they receive calls.
The system must be programmed to call a FM number after a specific event
occurs in order for that event to trigger the call.
To receive an event call:
1. Pick up the phone.
2. Say "Hello" or press [#]. The Event Announcement message is made, informing
you of a security situation in your system, for example:
“24 Oaklands Street, Intruder alarm, Ground Floor, kitchen”