Risco Agility 3 - Appendix B - Remote Control User Operations; Common Operations; Advanced Operations

Agility 3 User Manual
Page 39
Appendix B - Remote Control User Operations
The following section details the user operations from the Agility 2-Way Remote Control.
User operation can be defined to be activated by a quick mode or high security mode that
requires the use of a code.
Common Operations
Operation
Quick
High Security Mode
1
Full Set
> Code
Part Set
2
> Code
Full Unset
> Code
System Status
3
Long
4\?
Long
4\?
> Code
Output Control
4
A/B/C
Long / /
Long / / >
Code
Panic Alarm
+ simultaneously for 2 seconds
Clear Operation
5
>
Consult your engineer which commands are defined with a code.
Pressing > will cancel the Entry Delay time.
Pressing >
4\?
will give status indication only by the LED of the remote control and
not by local voice message.
Ask your engineer which device is assigned to which key.
Use this command to clear the remote control operation.
Advanced Operations
Operation
Quick
Code Sequence
Full Partition 1/2/3
Setting
/ / >
/ / > >
Code
Part Partition 1/2/3
Setting
/ / >
/ / > Code
Partition 1/2/3
Unsetting
/ / >
/ / > >