Rish Master 3430 User Manual

Pressing the “ Up” key sets the displayed value and will advance to “Energy on Modbus
menu.
Pressing “ Up key “ will advance to Energy digit reset count confirmation screen.
Pressing the “ Down” key will re-enter Energy digit reset count edit mode.
Note :
1) Default value is set to “14” i.e if energy count crosses 14 digit it will rollback to zero.
2) Energy displays on modbus is set to (2) & energy digit reset count is set to 12.
Energy screen on display will show “-------” i.e energy overflow .when energy crosses
the 11 digit count.
3) Energy displays on modbus is set to (3) & energy digit reset count is set to 9.Energy
screen on display will show “-------” i.e energy overflow .when energy crosses the 8
digit count.
Pressing “ Up” key accepts the presents value
and returns to measurement screen.
3.2.20 Energy Display on modbus
Pressing the “ Down” key will enter the “Energy Display
On Modbus Edit” mode and scroll the value through
the values 1,2 & 3 wrapping back to 1.
1 : Energy In Wh
2 : Energy in KWh
3: Energy in MWh.
VRY
KVAr
Sys
V
KW
VBR
Angle
Max
x1000
KVArh
x1000
IN
Ph R
P.F.
KWh
Ph B
A
VYB
KVA
Min
x1000
Hz
KVAh
Ph Y
%THD
x1000
Hz
KVAh
Ph Y
%THD
This screen enable user to set energy in terms of Wh / KWh / MWh on RS 485 Output
depending as per the requirement .Same applicable for all types of energy.
Ex. If energy display on modbus is set Wh & It will set Energy digit count to 10 then energy
will reset after “9,999,999,999” & then will Rollback to zero.
34

Rish Master 3430 Specifications

General

Brand	Rish
Model	Master 3430
Category	Measuring Instruments
Language	English