46
[Paper folding]
When you have connected an optional multifunction
nisher, copies can be folded.
[Booklet]
Automatically arrange pages on copies to create booklets.
When you have connected an optional multifunction
nisher, you can also specify stapling and folding.
[Imposition]
Arrange pages of the original in a booklet layout.
[Fold]
Create copies folded in two.
[Fold + Staple]
Create copies folded in two and stapled.
[Imposition] can be combined with [Fold] or [Fold +
Staple].
[Separate books]
When you have selected [Fold] and [Fold + Staple], some
restrictions apply to the number of sheets that can be folded at one
time.
[Fold] folds after 5 sheets (for 20 pages of originals), and [Fold +
Staple], after 15 sheets (for 60 pages of originals).
If the number of pages involved requires more sheets than this,
folding is done once after the number of sheets noted above to
produce an individual portion of the book, which is then ejected.
In this case, because the layout order varies depending on whether
these portions will be bound through the center or from the side,
choose [OFF] or [ON].
[OFF]
The layout is arranged so that each portion of the book ts inside
another portion when the book is bound (with a center binding).
Books are not stapled When you select OFF, even if you have also
selected [Fold + Staple].
[ON]
The layout is arranged so that each portion of the book is on top of
the next portion when the book is bound (from the side).
●
Example: 60-page original, [Fold], and [Separate books] OFF
p.11〜20+p.41〜50
②
① ② ③
p.1〜10+p.51〜60
①
p.21〜30+p.31〜40
③
Example: 60-page original, [Fold], and [Separate books] ON
p.21〜40
②
③
②
①
p.1〜20
①
p.41〜60
③
[Center margin]
When you have selected [Imposition], specify the center
margin width in a range of 0–50 mm (0–2"). Enter the
number using [▲] and [▼] or the numeric keys.
[Auto reduce]
When a center margin you have specied would cause the printed
image not to t on the sheet, the image is automatically reduced.
[Output tray]
When you have connected an optional multifunction nisher
or the stacking tray, specify the destination for copies.
●
ComColor Series Basic Guide 02
To Next Page
Loading...
