Page 19 DCN 4727 REV 6 Doc No. C29115
Unpacking Racks
Unpacking 7844.440
1. Remove plastic wrapping from packaged rack (please note label is attached to wrap).
2. Removed corner posts (x8)
3. Remove polybag.
Bolt-down Uninstallation
TIP / HEAVY EQUIPMENT
• This rack is easily tipped. Use extreme caution when handling.
• Instructed or Skilled persons to handle rack only.
o Only Microsoft approved SOP logistics systems to be used to move rack.
▪ This includes but not restricted to unbolting, removing from pallet, moving and
handling and final deployment.
• People handling the rack must wear PPE in accordance with local risk assessments and local
regulations.
• Unbolting of rack to take place on level surface only.
• Rack can roll off pallet easily once unbolted, remove immediately after unbolting.
• No external forces should be applied to rack during unbolting.
Failure to follow these instructions can result in death, serious injury or equipment
damage.
To Next Page