Page 22 DCN 4727 REV 6 Doc No. C29115
Unpacking 7844.477
1. Remove plastic wrapping from packaged rack (please note label is attached to wrap).
2. Removed corner posts (x4)
3. Remove polybag.
TIP / HEAVY EQUIPMENT
• This rack is easily tipped. Use extreme caution when handling.
• Instructed or Skilled persons to handle rack only.
o Only Microsoft approved SOP logistics systems to be used to move the rack.
▪ This includes but not restricted to unbolting, removing from pallet, moving and
handling and final deployment.
• People handling the rack must wear PPE in accordance with local risk assessments and local
regulations.
• Unbolting of rack to take place on level surface only.
• Rack can roll off pallet easily once unbolted, remove immediately after unbolting.
• No external forces should be applied to rack during unbolting.
Failure to follow these instructions can result in death, serious injury or equipment
damage.
Please note Rittal to not provide a ramp kit, or instruction to remove rack from pallet.
Please note that the rack is designed to be removed rear first off the back side of the pallet.
To Next Page
Loading...
