Page 8 DCN 4727 REV 6 Doc No. C29115
Important Safety Information
Read the instructions carefully to become familiar with the equipment before trying to install, operate,
service or maintain it. The following messages may appear throughout this manual or the equipment to
warn of potential hazards.
Safety Symbols
This is the safety alert symbol. It is used to alert you to potential injury hazards. Obey all safety
messages that follow this symbol to avoid possible injury or death.
The addition of this symbol to a Danger or Warning safety label indicates that an electrical hazard exists
which will result in personal injury if the instructions are not followed.
The addition of this symbol to a Danger or Warning safety label indicates that a tip hazard exists which
will result in personal injury if the instructions are not followed.
The addition of this symbol to a Danger or Warning safety label indicates that a lifting / manual handling
hazard exists which will result in personal injury if the instructions are not followed.
Warning – Do not stand on or climb on top of the racks. The racks are not designed for this purpose.
Rittal Factory Torque Setting - Rack to Pallet Interfaces
• Bolt down to pallet (M8, HEX HD): 7Nm (7844440)
• Bolt down to pallet (M10, HEX HD): 17Nm (7844477)
To be checked if bolt down has been interfered with.
To Next Page
Loading...
