Introduction
© robatherm 5
Pos: 13.5 /Sicher heitshinweise/!W artung&Reinigung_ATEX_ Oberflächenreinigu ng @ 0\mod_1256629592875_ 2008.doc @ 2028 @
To prevent danger of ignition due to electrostatic charge, all surfaces of ATEX units may
only be cleaned with a damp cloth.
Pos: 13.6 /Einleitu ng/Desinfektionsmi ttel @ 0\mod_12566296 66223_2008.doc @ 2029 @ 4
Disinfectants
Only use disinfectants with an alcohol base with country specific approval (e.g. RKI, VAH,
DGKH).
Pos: 13.7 /Einleitu ng/Wiederinbetri ebnahme @ 0\mod_125662968 9396_2008.doc @ 2030 @ 4
Recommissioning
After carrying out maintenance or disinfecting measures, ensure the unit is sufficiently clean
before returning to operation. Toxic or odorous substances must not come into the supply
air.
Pos: 13.8 /Einleitu ng/Dichtheitsprüf ung @ 0\mod_1256629717554 _2008.doc @ 2031 @ 4
Leak Test
In clean areas where there must be no transfer of particles from exhaust air to supply air, the
relevant parts must be tested for leakage annually or following any servicing (e.g. by means
of a suitable test gas). Observe manufacturer’s safety instructions! If necessary take suitable
measures to eliminate any leaks in consultation with the manufacturer.
Pos: 13.9 /Sicher heitshinweise/!W artung&Reinigung_ATEX_ Ersatzteilliefer ung @ 0\mod_1256630224350_ 2008.doc @ 2032 @
Supply of Spare Parts / Customer Service / Repair
Changes to the unit must only be carried out by qualified personnel. After carrying out
changes (e.g. installation of spare parts) a new assessment of conformity must be carried
out in accordance with the health and safety requirements of the ATEX guideline by a
qualified person with the relevant documentation before the unit is switched back on. Spare
parts must meet the specific requirements of the ATEX classification applied (category,
atmosphere, temperature classification). It is preferable to use identical original
components. If inappropriate changes are made to the unit by third parties, the robatherm
declaration of conformity ceases to apply.
Pos: 14 /Layout/Seite numbruch @ 0\mod_12566286 15637_0.doc @ 2284 @
To Next Page
Loading...