robatherm RM Series - Installation RMC; RZ; RM; RL

Installation RMC / RZ / RM / RL
6 © robatherm
Pos: 15 /Überschrif ten/_Montage @ 0\mod_1256 570138603_2008.doc @ 2010 @ 1
Pos: 16.1 /Überschri ften/__Anlieferung @ 0\ mod_125734126713 3_2008.doc @ 2037 @ 2
Delivery
Pos: 16.2 /Montage/W arenprüfung @ 0\mod_1257499 303681_2008.doc @ 2066 @ 4
Goods Inspection
On receipt of the goods they must be checked for damage and completeness. Missing parts
and damage must be noted immediately on the consignment note and be confirmed by the
driver. Details relating to procedures when damage is discovered are noted in detail on the
delivery note. If no such procedures are followed, no liability for defects will be accepted.
Pos: 17.1 /Überschri ften/__Entladung und Transport @ 0\mod_12573413 64587_2008.doc @ 2038 @ 2
Unloading and Transport
Pos: 17.2 /Montage/E ntladung und Transpor t @ 0\mod_1257499397431_2 008.doc @ 2067 @
All units are equipped with lifting eyes or transport loops.
Units without their own base frame are equipped for transportation with expendable pallets.
Only transport unit in usage position (not inclined or lying).
Unloading and transport should preferably be carried out with a crane or fork lift truck.
Pos: 17.3 /Sicher heitshinweise/Montage/ !Montage_Entladu ng_Vorsicht @ 0\mod_12574 99569021_2008.doc @ 2068 @
Caution
Serious bodily damage or material damage may be caused by falling loads.
Observe the safety instructions of the transporting vehicles.
Do not stop under an airborne load!
Pos: 17.4 /Montage/_K ran-Entladung und Tra nsport @ 0\mod_12574996857 75_2008.doc @ 2069 @ 3
Unloading and Transport by Crane
Pos: 17.5 /Sicher heitshinweise/Montage/ !Montage_Entladu ng-Kran_Achtung @ 0\mo d_1257499754847_200 8.doc @ 2070 @
Attention
Only use suitable and approved slinging devices (ropes, chains, lifting belts) for unloading
and transporting the units and only fasten them to the lifting eyes or transportation loops in
accordance with VBG 9a (UVV 18.4).
Pos: 17.6 /Montage/E ntladung und Transpor t_Kran-Entladung @ 0\ mod_1257499861415_2008. doc @ 2071 @ 44
Installation
RMC / RZ /
RM / RL