Robe iForte - Page 4

4
CAUTION! Risk group 2, RG-2
Avoid looking directly into the light source.
WARNING! This unit does not contain an ON/OFF switch. Always disconnect the power input cable
from mains to completely remove power from unit when not in use or before cleaning or servicing the unit.
When choosing the installation spot, please make sure that the xture is not exposed to extreme heat or dust.
Do not block the front glass cover with any object when the xture is under operation.
The xture becomes very hot during operation. Allow the xture to cool approximately 20 minutes prior to ma-
nipulate with it.
Only operate the xture after having checked that the housing is rmly closed and all screws are tightly fastened.
Always use a safety wire for overhead installation.
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the xture.
The maximum ambient temperature must never be exceeded.
CAUTION!
The front glass cover has to be replaced when it is obviously damaged,
e. g. due to cracks or deep scratches!
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualied for operating the device. Most damages are the result of unprofessional operation!
CAUTION!
To avoid damage of the internal parts of the xture head, never let the sunlight
(or other light source) lights directly to the front glass cover, even when the xture
is not in operation !
Please use only an original ROBE packaging (paper box, loader case or foam shell) for
transporting the device, otherwise potential damage of the device during its transport
will not subject to warranty .
Do not touch the device’s housing bare hands during its operation (housing becomes hot)!
For replacement use fuse of the same type and rating only.
The xture housing never must be covered with cloth or other materials during its operation. Do not block fans
or fans ventilation slots with any object. Fans and ventilation slots must remain clean.
The xture must not come into contact with sea water (salt water).
Damages or corrosion issues resulting from salt water will void
the manufactures warranty and will not be subject to any warranty
claims or repairs.