Robe iForte - Tab Manual Control; Tab Stand-Alone

38
and keeps a direction of rotation.
Max. Speed & Follow Dir. - Gobo goes from its rotation to desired indexed position with max. speed
and keeps a direction of rotation.
Date & Time Settings - Use this menu to set current date and time for the xture log system (menu "View
Logs"). Set this menu items before rst xture operation.
Focus Tracking - This feature provides automatic sharpness re-adjustment during zoom movement, after an
initial sharpness has been set by the operator by setting the focus channel and enabling the FocusTracking. The
Focus Tracking feature is done via automatic movement of focus element, taking into account several internal
parameters, zoom position being one of them. To utilize the Focus Tracking, make sure to enable the Focus
Tracking, set the Zoom to value 200 and adjust Focus to desired sharpness. Then, while keeping Focus value
untouched, you can move the Zoom. Fixture will automatically keep the projection at the desired sharpness
as much as possible. You can also re-adjust the Focus value over time if needed. When switching between
Gobo wheel 1, Gobo wheel 2 and an empty aperture, the Tracking Focus will adjust the internal parameters,
therefore providing desired sharpness by adjusting the Focus might be required. If you use both Gobo wheel
1 and Gobo wheel 2 without further adjusting the Focus value, Gobo wheel 2 will be automatically used for
Focus Tracking 's focusing.
Default Settings - The menu item allows to set all xture parameters in this menu to the default (factory) values
except items "DMX Input".
Password Protection - allows to enter password in order to prevent unauthorized person from changing setting
of the xture. Password is set to 7623 and cannot be changed.
Reset Web Password - The menu item allows you to reset a password for access to the REAP (default pass-
word: 2479, user: robe).
9.4 Tab "Manual Control"
Reset Functions - The menu allows to reset the xture either per function modules or all modules together.
Total System Reset - The item resets all function modules.
Pan/Tilt Reset - The item resets a pan and a tilt.
Colour System Reset - The item resets colour wheel 1/colour wheel 2 and CMY+CTO system.
Gobo/E󰀨. Wh. Reset - The item resets rotating gobo wheels and an e󰀨ect wheel.
Optics/Prism/Frost Res. - The item resets a zoom, focus, prism and a frost module.
Iris/Framing Sh. Reset - The item resets an iris module and framing shutters.
Manual E󰀨ect control - Use the menu to control all xture channels by means of the control panel.
9.5 Tab "Stand-alone"
Test Sequences -Use the menu to run a test/demo sequences without an external controller, which will show
you some possibilities of using Robin iForte.
Dynamic Mode - This mode uses all Robin iForte functions including pan/tilt movement and therefore
is good for a complete introduction of the xture.
Static Mode - This mode is suitable for projections on the wall, ceiling or ground without any pan/tilt movement.
Adjust the pan, tilt, zoom and focus to desired positions an start test sequences by touching the green icon.
Music Trigger - Use the item to activate the sound control of the running program via the built-in microphone.
Preset Playback - This menu allows you to select the program which will be played in a loop after switching
the xture on (the option is commonly used in a stand-alone operation without an external controller).