Robe iForte - Checking and Replacing the Silica Gel Desiccants

61
14.4 Checking and replacing the silica gel desiccants
The silica gel desiccants are used for humidity indication in the xture. Dry silica gel has an orange colour, if it
is saturated with water, its colour changes to dark grey. If most of silica gel changed colour to dark grey, it has
to be replaced.
Unplug the xture from mains before checking/replacing silica gel desiccant!
Do not check/replace silica gel desiccant in a damp environment (e.g. rain, snowfall)!
Spare desiccants from factory are packaged in a protective foil. Take desiccants out of
the protective foil immediately before replacing them in the xture!
Silica gel may become damp if it is exposed to wet air for longer time.
Silica gel is not under warranty!
Desiccants are placed in the xture on the following places:
xture head - 2x small box with silica gel
xture arm without tilt lock - 2 x tube with silica gel
xture base - 2 x small box with silica gel
Fixture head
Fixture base
Boxes with silica gel
Box with silica
gel
Box with silica
gel