Robe iForte - 12 Nfc; 13 Cleaning

50
12. NFC
The xture supports NFC (Near-Field Communication). Using the mobile phone application ROBE COM you
can read and set the Robin iForte parameters (DMX address, IP address...etc.), get information about temper-
atures, operation hours, RDM identication etc.
The NFC point is situated on the front panel of xture´s base.
Download and install the ROBE COM from Google Play (for Android 5.0 and higher) or App Store (for iOS 12.0
and higher) to your mobile phone. Your mobile phone has to support NFC.
Hold the mobile phone on the side of the xture base, if NFC connection is OK, discovered xture will appear
on the screen, after touching the xture name the following the following menu items will appear:
DMX/RDM settings
Ethernet settings
Blackout settings
Colour settings
Display settings
Standalone settings
Pan/Tilt settings
Other settings
Software versions
Device hours
Device temperatures
Touch desired menu item to enter its submenu.
13. Cleaning
DANGER !
Always disconnect the xture from mains before starting any cleaning work.
Regular cleaning will not only ensure the maximum light output, but will also allow the xture to function reliably
throughout its life.
The frequency of cleaning depends on the environment in which the xture operates: damp, smoky or particu-
larly dirty environments can cause greater accumulation of dirt on the xture housing.
The front glass cover of the head will require cleaning on a monthly basis. A soft lint-free cloth dampened with
a solution of water and a mild detergent is recommended, under no circumstances should alcohol, solvents or
abrasives be used!
Stains caused by hard water (water that has high mineral content) can be e󰀨ectively removed by means of
non - abrasive descaler (e.g. EverStar descaler).