Robe iForte - Tab Address; Tab Information

32
9.1 Tab " Address"
DMX Address - Select the menu to set the DMX start address.
Blinking DMX address means that the xture is either not receiving DMX data or that the set DMX address is
higher then allowed, exceeding the DMX footprint of the set DMX mode.
DMX Presets - The menu item allows you to choose desired DMX mode.
Ethernet Settings - The menu allows all needed settings for the Ethernet operation
Ethernet Mode
Disable - The option disables Ethernet operation.
Artnet - Fixture receives Artnet protocol
gMAI - Fixture receives MANet I protocol
gMA2 - Fixture receives MANet 2 protocol
sACN - Fixture receives sACN protocol
Ethernet To DMX - Fixture receives protocol from the Ethernet input and sends DMX
data to its DMX output (xture works as an "Ethernet/DMX converter", next xture can
be connected to its DMX output and you can build a standard DMX chain by connecting another xtures.
Only one xture has to be connected to the Ethernet.
IP Address/Net Mask - Select this menu to set IP address. IP address is the Internet protocol
address. The IP uniquely identies any node (xture) on a network.
There cannot be 2 xtures with the same IP address on the network!
Default IP Address -Preset IP address, you can set up only rst byte of IP address
(2 or 10) e.g. 002.019.052.086.
Custom IP Address - The option enables to set up all bytes of IP address.
Net Mask - The option enables to set up all bytes of Net Mask.
ArtNet Universe - Use this item to set a Universe (0-255). The Universe is a single DMX
512 frame of 512 channels.
MANet Settings - Use this menu to set parameters for MANet operation.
MANet Universe I/II - The value of this item can be set in range 1-256.
MANet Session ID - The value of this item can be set in range 1-32.
sACN Settings - Use this menu to set parameters for sACN operation.
sACN Universe - The value of this item can be set in range 1-32000.
9.2 Tab "Information"
Fixture Times - The menu provides readouts of xture and LED module operation hours.
Power On Time - Select this menu to read the number of xture operation hours.
Total Hours - The item shows the total number of the operation hours since the
Robin iForte has been fabricated.
Resettable Hours - The item shows the number of the operation hours that the
Robin iForte has been powered on since the counter was last reset.
In order to reset this counter to 0, touch the text box next to the item "Resettable Hours:"
Fixture Temperatures - The menu is used to view temperatures of the xture´s inside.
LEDs temperature - The menu shows temperature on the LED PCB in the light source.
Current - A current temperature of the LED PCB.