Robe iForte - Disposing of the Product

63
Example of dry silica gel and silica gel saturated with water:
State of desiccants in the xture arm can be checked:
- visually by unscrewing the cover of xture arm
- via xture display (tab Information, option RAINS Status):
- remotely by means of the Robe Ethernet Access Portal (REAP):
In case that silica gel in the xture arm is fully saturated with water, the warning message " Too Much Humidity
in Device" will appear on the xture display (yellow warning icon) and also in the Robe Ethernet Access Portal
(Logs screen).
Example
14.5 Disposing of the product
To preserve the environment please dispose or recycle this product at the end of its life according to the local
regulations and codes.
Silica gel saturated
with water
Dry silica gel
The chart MAX WET is decisive for
replacing dessicants in the xture arm.
If the chart has changed to black co-
lour, dessicants have to be replaced.
It is not necessary to replace silica gels
desiccants in plastic boxes in the x-
ture head and base. These desiccants
should be checked (and replaced if it
is needed) at removing head or base
covers, e.g. at gobo replacement or
some service intervention.