Roberts Rambler Max - Configuration; Plugging in and Language Selection

9
Conguration
Plugginginandlanguageselection
Your radio may be congured using either the display and buttons on the radio, or by
using the Oktiv app.
1. Plug the cable from the mains adaptor into the DC input socket located underneath
your radio (marked
) ensuring that the plug is pushed fully into the socket and place
your radio on a at surface.
2. Plug the mains adaptor into a wall socket and switch on the socket.
IMPORTANT: The mains adaptor is used as the means of connecting the radio to
the mains supply. The mains socket and any multi-way mains block used for the
radio must remain accessible during normal use. In order to disconnect the radio
from the mains, the mains adaptor should be removed from the mains socket outlet
completely.
3. When you apply power, the display on the radio will light up and show a start up
screen for a few seconds. If this is the rst time that you use your radio (or after a
Factory Reset) the display will then show the language menu.
4. By default your radio will display all menus and messages in English. Rotate Tuning
to highlight the desired language. Press Tuning to enter the selection. Your radio will
display a privacy policy. Please read the privacy policy and then press the Tuning
control to accept the policy. The radio will then show 'Setup Wizard' and 'YES' will
be highlighted on the screen.
5. Press Tuning to select 'YES' and to begin setting up your radio
Continue on the next page.
Setup Wizard
Start now?
English
Dansk
Nederlands
Français
Deutsch
Italiano
Language
*
FM
DAB
60