Roberts Rambler Max - Manual Network Configuration

16
Conguration.
Connection Type
Wireless
IP settings
IP address
192 . 168 . 1 . 25
Subnet mask
255 . 255 . 255 . 0
SSID:
mynetwork
Network Settings
Please Wait
Connecting...
0 1 2 3 4 5 6
7 8 9 . _ - @
,
a b c d e
f g h i j k l
m n o p
q r s
Network Wizard
PBC Wlan Setup
View Settings
Manual Settings
NetRemote PIN Setup
Network Profile
Network Settings 10:30
Manualnetworkconguration
Note: Most users will not need to use manual network conguration.
If you do not wish to use DHCP for automatic network conguration, then you will need to enter some
network settings manually. This facility is provided to allow the product to be used with networks where the
conguration of devices is not managed by the router, or if your network is congured with a hidden SSID, or
where customised settings may be required. In such cases it is assumed that the user already has sufcient
knowledge to understand the terms and settings used for this purpose. IPv4 address schemes are used.
1. From the radio's Network Settings menu, select 'Manual Settings'. You must then choose to connect using
the 'Wireless' connection. There are as many as nine 'Wireless' settings screens, shown by the '1 of 9'
progress marker in the top right corner of the display.
2. The subsequent menus allow conguration of the following parameters:
DHCP - On or Off
IP address - e.g. 192.168.1.25
Subnet mask - e.g. 255.255.255.0
Gateway adress - e.g. 192.168.1.1
DNS address (primary and secondary addresses)
SSID - needed for WiFi connections if the SSID is not broadcast
WEP / WPA / WPA2 key and settings
When entering the SSID or the WiFi pass key, the three controls on the right-hand side of the screen have
special functions. You can quickly access these by pressing the Info button and then use the Tuning
control as needed:
select ' ' to erase a character just entered (long press to clear); Info again to continue
select ' ' when the complete encryption key has been entered
select ' ' to cancel and go back to the TKIP / AES options screen
3. Upon completion of the settings the radio should connect to the network. If the connection is made
successfully, the radio will return to the Network Settings menu. If the unit cannot connect, then it will display
a 'Failed to connect' message. You will then need to identify which setting may need to be changed, or
whether some other network issue is responsible. Once connected to the network, the settings are saved.
They are retained in memory while the radio is disconnected from the mains.
FM
DAB
60