Roberts Rambler Max - Headphone Socket; Auxiliary Input Socket

44
DisplayandAudio.
Headphone socket
A 3.5mm Headphone Socket is located on the underside of your radio.
Inserting a plug automatically mutes the internal loudspeaker. Please be aware
that the sensitivity of headphones can vary widely. We therefore recommend
setting volume to a low level before connecting headphones to the radio.
IMPORTANT: Excessive sound pressure from earphones and headphones
can cause hearing loss.
To prevent possible hearing damage, do not listen at high volume
levels for long periods.
Auxiliary input socket
A 3.5mm Auxiliary Input socket located on the underside of your radio for
connecting the audio signal from an external audio source such as an MP3
or CD player.
1. Connect a stereo lead from the headphone output of your MP3 or CD
player to the Aux In socket located under the radio. Typically this lead will
have a 3.5mm stereo plug at both ends.
2. Switch on your radio and press the Mode button until 'Aux In' mode is
shown on the display.
3. Press 'play' on the connected audio device. If you are using its headphone
output for the connection, set its volume control to a level of somewhere
between two-thirds and maximum (the objective is to get a strong audio
signal but without too much distortion). Then adjust the volume on the
radio as required.
4. After use, disconnect your player in order to listen to your radio
conventionally.
FM
DAB
60