Robopac ECOPLAT PLUS BASE - Setting the Wrapping Cycle End Delay

ENG
INFORMATION ABOUT THE USE
58
6.6. SETTING THE WRAPPING CYCLE END DELAY
This operation serves to set the film carriage overrun during the upstroke phase, after the photocell has determined the
height of the pallet (only for ECOPLAT PLUS model machines).
1 Turn the main switch (A) to “I” (ON) to activate the power supply.
2 Wait for the blue light on the "Reset" button (G) to turn on.
3 Press and hold down the buttons (E1-E2), and then press the "Reset" button (G).
Keep the buttons pressed until the film carriage reaches the desired distance.
4 When the buttons are released, the film carriage stops and its "overrun" movement is saved.
5 Turn the main switch (A) to “0” (OFF) to switch the machine off.
The machine is ready to start the cycle.